Subject | Text |
| Possibility : 1. Regulator over voltage.
2. Capacitor at horizontal transistor ( c |
Panasonic | Since you don't gave a model number, it is hard to be specific but you are probably correct in suspe |
|
| phosphor type and deflection yoke assembly differs
check inductances and judge yourself
if both tv |
Sony GDM500PS - Please HELP: red signal fluctuations | Hello.
This is actually monitor with Sun logo that came with SPARC workstation. Its FCC ID is AK8 |
| You come out of the blue.
You need to start witht the basics. "What was the tv doing before sh |
GDM1950 | I designed a little circuit that changes the horisontal and vertical pulses to the right modes regar |
Zenith PVY4665RK | :( I have a Zenith projection tv(PVY4665RK) with 3 vertical lines in top
4 or 5 inches of screen, |
LG Studioworks 700S 17" CRT Monitor - b&w colour | Hi All,
Here is a tip for a LG Studioworks 700S 17" CRT Monitor repaired today.
Symptom: Scre |
Hitachi 50UX53K PTV, intermittent crosshatch | Hi,
This set is blinking between normal picture and a crosshatch pattern. Deflection/Power board |
vert or horiz problem? | 1st - It's JTS1957 / NOT JTS1975. Oh, to be 18 again! How did we get from a discussion of a Vertical |
NEC CT 2660A shmatic and circuit layout and parts list. | I am in need of the above items in hopes of repairing my old Nec Monitor TV
CT 2660A. The set has |
Jvc model AV-14MG3B | Resold the vertical I/C. You have dry joints on that part.
Regards Ismael |
| Can you hear any high voltage, when the TV starts?
if not, try to measure the secundairy voltages |
tv panasonic 29" and 34" | Hi there.I need several information for modified of deflection yoke type TLY15467F,TLY15466F and TLY |
| I would check the deflection board and yokes first as thats a DP14G I have seen issues with the defl |
Goodmans 32" TV. Picture size fault | Hi,
I have a Goodmans 32" TV that has developed a fault with the picture size. The picture does |
Re: my rca big screen tv | [quote:b86c726fdd="eyegriff"]my rca big screen tv just sounds an alarm when plugged in..no picture
|
|
vertical | excuse me for my bad english..
falt is in powers supply..
probably vert srage fault for low voltag |
Hitachi | It will probably be one of three things:
!. A bad solder joint on the vertical IC601
2. No 9 volt |
Re: Sony tv | [quote:e2732ed2eb="picasso"]Hi Buddy 128,
Resolder vertical output stage and check R518 , R519 (0 |
Re: Panasonic 27 inch TV CT-27G5CB | [quote:ab90ebd64e="michaelmcm"]If anyone could please shed some light on my problem with
a panasoni |
Sony CDP E200 monitor help | I appreciate you guy's help. I'm sorry to say the way things are at home I don't have all that much |